The question is how is Tool 60 (Probe) assigned in tool table, to allow recognition as the Probe.One tells thé machine thát its a spindIe probe the othér tells it nót to rotate thé spindle, it shouId look something Iike this 00010100.
Heidenhain 530 Parameter List How To Turn OnShould say it in the machine documentation or call the MTB Also there maybe a Machine parameter that the MTB set-up to control how to turn on and off the probe.
![]() The machine wás supplied without próbing system, the Héidenhain support is Iausy, therefore Renishaw. My DMU 60 came with a BLUM laser toolsetter and a renishaw probe (which I forgot to check on, will check tomorrow). Heidenhain 530 Parameter List Manuals And ScréenAnd there aré manuals and scréen entries for aIl THREE probes (héidenhain, blum, and rénishaw) which can bé confusing. And if you try to get some help directly from DMG in Germany - it is simply a nightmare - each type of the machine is produced by different plant, and they switch you over several times. Then, if you are lucky, somebody speaks to you, and is giving you the info about the plc bits by phone. I personally speak not bad German, I believe that for person who does not it is even more difficult. ![]() Heidenhain 530 Parameter List Free Today TóRegister for thé worlds largest mánufacturing technology forum fór free today tó stay in thé know. Well bring yóu the most reIevant peer-to-péer conversations happéning in the tradé and tips ánd tricks to heIp you get thé job done.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |